Your water heater is one rather used and more expensive appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating as well as costs.
Regular flushing of one’s water heater are probably the single most important step you consider to prolong its service life and to save energy. During time, sediments mount up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most involving the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double daily life of your hot water heater from 3-5 to 7-10 years. And with the costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is in today’s economic condition. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a month or so.
To drain your water heater, on the internet should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located more than a water inlet line going into your water heater. You can then connect a hose to the drain valve located at the base of the heater tank. Open the drain and allow it to run until all on the water has emptied from the hot water heater. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until water flows out quickly. This will allow air to vent via the heater and the water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so may be less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to work for you.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610